No hay artículos en el carro
No hay artículos en el carroWolfride - Juego de 4 piezas de fresas de carburo de tungsteno de vástago largo de 6 mm, juego de fresas para metal de 5.9 pulgadas de largo
Angie hernandez
Comentado en los Estados Unidos el 29 de marzo de 2025
Buen producto me gustaron es el temaño que yo quería
LW3
Comentado en los Estados Unidos el 17 de febrero de 2025
They're well made, and they survived a lot of use recently. I highly recommend!
Hector
Comentado en los Estados Unidos el 10 de julio de 2024
They hold shape on heavy-duty, stay sharp, and the size is very helpful
Atomic Reverend Handyman
Comentado en los Estados Unidos el 17 de febrero de 2024
I am making this review to hopefully answer the questions I had before I purchased these that I found only vague answers to.I used these bits to port 460 (7.5L) Ford cast iron cylinder heads, I matched both the intake and exhaust ports to the gaskets and removed a large cast iron "bump" in the exhaust port to hopefully create a little more horsepower. These bits worked excellent for my intended purpose and they didn't create a lot of heat. All total I did 8 intake ports, 8 exhaust ports and 8 intake manifold ports plus once I was done doing the serious work I decided to take off the casting boogers and mold flange marks from when the engine was made since it was out of the car. These bits worked all the way to the end, if I had to guess I would imagine they would do a few more engines before becoming dull.One thing I should mention The bits are I am pretty sure metric in their diameter (6mm) where a typical collet is (6.21mm) ¼" the collet on my air die grinder tightened up ok but when I went back to use a quarter inch shank bit I had to use a tiny screwdriver to open the collet back up. It wasn't a big deal but it is something to be aware of.Now for some Captain obvious thingsWear googles, the cast iron "chips" are not sharp but they really fly out and sometimes they end up in your face and also I would recommend a face mask so you don't inhale them to quote my mother "you only get one set of lungs".Anyways I hope this helps... Oh and the bits are about 6" long (150ish MM) for anyone wondering.
stevan
Comentado en los Estados Unidos el 22 de septiembre de 2020
works great in a drill. when used in an electric die grinder, the lack in thickness allows flex and a lot of wobble in the bit. to cut down on wobble, a couple of inches will need to removed if prefer to use in die grinder.
Productos recomendados
Mex $228.38
Mex $ 125 .00 Mex $125.00
Mex $1,283.52
Mex $ 539 .00 Mex $539.00
Mex $638.00
Mex $ 306 .00 Mex $306.00