No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Customer
Comentado en los Estados Unidos el 12 de febrero de 2025
Great endmills and a great price. I use them on hardened tool steel and had no issues.
Ben
Comentado en los Estados Unidos el 25 de enero de 2025
Bought these for a hobby. Received them and like that they are packaged individually, thus helping keep them sharp. Used them on a firearm building project and only eneded up using one. But stayed sharp and met the needs of what I was using it for. If your are a hobbyist and looking for some high quality milling bits with out having to pay a premium these are the ones to go to.
The Inspector
Comentado en los Estados Unidos el 2 de enero de 2025
I had been using a different brand which just wasn't cutting very well so I tried these. I was able to increase my feed rate by about 30% and the depth of cut by over 100% and they cut like butter! The only problem came towards the end of the cut as it met the spoil board. I snapped off three different bits trying to make the final pass. I ended up switching back to the bit that didn't cut very well, and used it to make my final pass without much of an issue, other than having to slow the feed rate down significantly again.These were the 1/8 inch flat and mills. I have some quarter inch speed tiger bits that I will be using next week.. and I'm hoping for a little better strength.
Customer
Comentado en los Estados Unidos el 2 de abril de 2025
Good value
dmitriy
Comentado en los Estados Unidos el 14 de noviembre de 2024
Held up very well cutting 304 stainless even under sub-optimal feeds and speeds, which were the limitations of my CNC. I tried another (different brand) popular carbide end mill on the same job / stock subsequently for comparison. The other end mill ground itself into a needle due to intense heat. But this Speed Tiger came out of the same job intact and still sharp.
Productos recomendados
Mex $500.03
Mex $ 230 .00 Mex $230.00
Mex $588.08
Mex $ 317 .00 Mex $317.00