No hay artículos en el carro
No hay artículos en el carroMás información del producto
匿名
Comentado en Japón el 7 de mayo de 2025
前のが古くて変形したので交換しました。しっかりついて良いですね
Ron From GA
Comentado en los Estados Unidos el 10 de mayo de 2025
I've used these Maxxair vent covers on my other RVs, so I already knew about the quality and efficiently of these covers. These are a must to keep out the rain from soaking your RV if you keep the vent open. I installed them myself and the hardest part of the job is crawling up on top of the RV. Take your time, follow the instructions and they install easily and securely. two tips to make life easier for you, when you set the cover down the first time to measure (eyeball) prior to marking it, lift it up about 2 inches to check and make sure your brackets will contact the metal in the RV roof vent. Next, when you measure for the original fit, close the RV vent so the new Maxxair cover fits easily over the existing RV vent. Then, after you have your marks, then open the RV vent fully to access the metal rim of the RV vent to drill. (it's nice to have a helper in the RV to raise and lower the RV went or it's you, up and down the ladder.
Jill Elliott
Comentado en Canadá el 25 de agosto de 2024
Great product and excellent quality. Installation was very simple. Works great.
Héctor Barón
Comentado en México el 6 de julio de 2024
La instalación es complicada, a pesar del instructivo se requieren materiales especiales como por ejemplo una claraboya que sea de metal ya que va anclada a la misma y si es de plástico se puede romper.
Jean-Claude Doucet
Comentado en Canadá el 16 de octubre de 2024
Parfait Sur ma remorque fermée
Winegolfing
Comentado en Canadá el 11 de septiembre de 2024
Ordered three to cover existing vent covers that perpetually degraded from UV exposure, even though the trailer was tarped for 6 months over the winter…..easy installation, place the cover over the vent, approximating a centered position, this is the most time consuming part , mark the locations through the vent holes on the roof, place the angle brackets over the roof markings and this will locate the position to drill on the vent frame. The washers that go on the inside of the vent frame may be problematic if you have a plastic frame protruding up the interior sides of the vent…..I found the washers fit by placing them on first, sliding the washer between the plastic interior trim and vent wall, place the screw from the outside in through the drilled hole through the washer, then expansion washer, then secure with supplied nut.The positioning and drilling take most of the time, securing with nuts is easy. Apply anti-seize paste to the outside bolts securing the cover to the angle brackets and do not over tighten to avoid cracking the cover.
Productos recomendados
Mex $678.74
Mex $ 366 .00 Mex $366.00
Mex $773.00
Mex $ 409 .00 Mex $409.00
Mex $6,047.78
Mex $ 1,881 .00 Mex $1,881.00
Mex $362.09
Mex $ 166 .00 Mex $166.00
Mex $1,384.77
Mex $ 692 .00 Mex $692.00