Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Channel Master CM-3414 TV Signal Amplifier - Amplificador de señal de TV (White)

Envío gratis en pedidos superiores a Mex $600.00

Mex $1,743.46

Mex $ 784 .00 Mex $784.00

En stock

Acerca de este artículo

  • Funciona con todas las antenas de TV e instalaciones CATV (no compatible con satélite
  • Mejora la fuerza de la señal, disminuye la pixelación y puede aumentar el número de canales
  • Tamaño miniatura para instalaciones que ahorran espacio



Más información del producto

maestro de canal, amplificador de distribución, antena de TV, preamplificador, amplificador de señal, 3414, amplificador de caída, hd

Amplificador de señal HDTV de 4 puertos

Channel Master ha estado a la vanguardia de los productos y soluciones de entretenimiento de transmisión por aire, proporcionando la más alta calidad y valor a los consumidores desde 1949. Con sede en Chandler, Arizona (Phoenix), Channel Master ofrece una portafolios completa de antenas de TV por aire, DVR OTA, equipos de montaje de antena de TV, amplificadores, cables, conectores y mucho más.

Ultra Mini 4

Descripción

El amplificador de distribución Ultra Mini 4 aumentará las señales de TV, aumentando la intensidad general de la señal para su distribución en toda la casa. El Ultra Mini 4 tiene cuatro puertos de salida y se puede utilizar en aplicaciones de distribución de RF HDTV, CATV, off-air, analógicas y digitales donde se requiere un alto rendimiento y fiabilidad.

Contenido del paquete:

• Amplificador de señal de TV de 4 puertos ultra mini

• Adaptador de corriente

• Cable coaxial RG6 de 6 pies

• Guía del usuario

Características

• Cuatro puertos de salida amplificados (8 dB)

• Funciona con todas las instalaciones de antena de TV y CATV

• Mejora la intensidad de la señal, disminuye la pixelación y puede aumentar el número de canales

• Tamaño miniatura para instalaciones que ahorran espacio

• Carcasa recubierta de polvo y sellada para la intemperie que permite la instalación en interiores o exteriores en cualquier clima

Especificaciones:

  • entrada de voltaje de la fuente de alimentación: 110-240 V, CA ~ 50/60 Hz, 200 mA (máx.)
  • Voltaje de salida de la fuente de alimentación: +13.2 V CC, 500 mA, 6.6 W (máx.)
  • Rango de frecuencia: 54 a 1002 MHz (adelante), 5 a 42 MHz (ruta de retorno)
  • Ganancia: 8 dB
  • Figura de ruido: Normalmente menos de 2 dB. Aislamiento: 24 dB
  • Nivel máximo de salida/entrada: 18 dBmV, 10 dBmV
  • Retorno pasivo: -8.0 dB
  • Temperatura de funcionamiento: -40 °C a +60 °C
Channel Master, distribución, amplificador de señal HDTV, antena de TV, preamplificador, divisor, 3414, cable

Long time ian
Comentado en los Estados Unidos el 7 de febrero de 2025
Do yourself and use on of those instead of one of the cheaper alternatives.This device will do the job you need done. Provides great picture quality the first time. Well made, durable, and well designed. Much much much better than cheap alternatives. Trust me, this is the device you want to use to give you a good signal and picture.
Roger
Comentado en los Estados Unidos el 3 de abril de 2025
Quality device. Coupled with a rooftop antenna I receive 30+ unfiltered, crystal clear channels. This is really a great piece of equipment.
James H.
Comentado en Canadá el 12 de agosto de 2020
When I first installed my OTA antenna, I already had the signal going to two TVs and got reception of 37 channels. According to TVFool, I got all the nearby signals that I was aiming for (CN Tower and Buffalo broadcasts), but not two Hamilton stations. When I split this into three TVs, I lost most of the Buffalo stations due to weakened signals.To resolve this issue, I got the 4-way distribution amplifier from Channel Master and hooked up the three TVs, leaving the fourth port unused (on a side note, I am using the pre-existing coax setup from my long-ago cable TV provider housed in an outside plastic case to pull in the OTA signal).The net result of this was that I got all of my stations back, and I got the two Hamilton stations too! So the Hamilton stations were likely too weak when I split it into two, but were restored when I used the distribution amplifier.The amplifier itself is sturdy and heavy with a smooth painted finish, so it would last even if it were completely exposed to the elements. I love that the input power is provided through a coax cable because you can use your existing coax cable installation to provide power to the unit without running another power cord into your box. I simply plugged the wall wart near one of my unused TV jacks, used a short coax cable to connect the wall wart to the jack, then connected the other end of the corresponding coax line to the power input of the unit. Very easy and I didn't have to use one of my outdoor AC outlets to power the unit. Just make sure that the power-providing coax line is completely isolated and is not connected (via splitter) to any other cables, then test the voltage (~13V DC) of the other end of the power coax cable before you screw it into the unit.
Y más novedades
Comentado en México el 29 de enero de 2019
Bueno pero a la primera lluvia se fundió el eliminador
JR Quegamez
Comentado en México el 10 de agosto de 2018
funcional, cumple lo que indica la publicacionbuena calidadrelacion precio/calidad muy buenarobusto y hace lo que indicarecomendable
VICTOR LEON
Comentado en México el 26 de julio de 2018
NO SE YO NO LO CONECTE PERO EL RESULTADO ES BUENO 1 1 1 1 1 1 1 1 1
Dave E
Comentado en Canadá el 22 de julio de 2018
I was getting 15 OTA channels (using a single ClearStream 2V) in Hamilton, Canada using a 4 way unamplified splitter. Added a LNA-200 pre amp and got 20 channels with a 4 way splitter being used. If I hooked the antenna direct to 1 tv (no splitter) I got 30 channels so I bought this CM-3414 dist amplifier to use with the preamp. Hooked the 4 way back up and now have 30 channels. A few Buffalo channels (2.1, 2.2, 2.3, 2.4) are on the edge but I point the antenna between Buffalo and Toronto (prevents potential over amplification issues but to be honest, it did not seem to be a problem with this setup) and it still pulls in Buffalo channels. Satellite dish has been removed ! May get a longer range antenna but cannot complain given how cheap this system is and the number of channels. CM-3414 is a great product but I may have been better off hooking up 2 tvs and using a 2 way splitter to get the '2 channels'. Channel 2.1, 2.2, 2.3, 2.4 had absolutely no picture with an unamplified 4 way splitter (signal strength below 20%) so this dist amplifier definitely is worth the money. It is also well constructed with great connectors and I like how it is powered through a coax cable (it even comes with one).
Cliente de
Comentado en México el 16 de mayo de 2018
Tengo el servicio básico de televisión por cable y suele llegar débil la señal de los canales, y siempre se ven con estática o como si se encimara un canal sobre otro (se ven imágenes opacas de un canal en otro canal), por ello decidí comprar este amplificador de señal y realmente mejoro la calidad de la señal, ahora se ve sin la estática y sin imágenes encimadas, sin embargo, para que funcione el Amplificador se debe mantener todo el tiempo conectado a la luz eléctrica porque si se desconecta la señal se ve mal y con mucha estática pero cuando se conecta se ve muy bien, ademas no afecta el servicio de Internet por el contrario parece ser que ligeramente lo mejora un poco (el servicio de Internet es por cable). Si tienes interés en mejorar tu señal de televisión sin afectar tu Internet por cable considera comprar este producto, porque realmente es útil y funcional como Amplificador.Ventajas:-Mejora la Señal de Televisión (la Amplifica y se ve mejor la imagen del canal)-No hay perdida en la señal de Televisión o Internet por cable y ligeramente mejora esta ultima un poco (No es un divisor/splitter por lo que no disminuye la señal)-Es fácil de Instalar, tan solo se conecta un cable coaxial a un regulador de voltaje que el mismo producto trae, y después solo se conectan los cables al amplificador y a la luz para que el aparato funcione (trae un manual donde se muestran las conexiones, sin embargo recomiendo ver tutoriales por Internet para una mejor comprensión de su uso).-Tiene 4 salidas para la señal (Solo he usado 2; una para el cablemodem que es el internet y otra para la señal de televisión y ambas funcionan correctamente)- No se calienta en exceso, el Amplificador lo he utilizado dos días seguidos y su temperatura es lo que podría considerarse como normal (se siente tibio)Desventajas-Si el Amplificador esta desconectado de la corriente eléctrica la señal se ve con mas estática (Si no conectas el Aparato a la corriente electrica y lo quieres usar sin luz como si fuera un divisor de señal no te servirá, porque la imagen se ve mal)-Si se va la luz el Aparato no mejorara la señal, solo pasará una imagen de los canales al televisor con estática (Sin embargo si se va la luz tampoco funcionará la televisión)-Es un Aparato algo caro.-Necesita estar conectado a la luz eléctrica, o si - no la señal de Televisión no se observará bien.
Raul Vazquez
Comentado en México el 16 de febrero de 2018
Muy bueno, me fue de mucha utilidad para el proposito por lo cual lo compre, si cumplio con mis expectativas.
Daniel
Comentado en México el 31 de diciembre de 2016
Cumple su función a la perfección y su materiales son excelentes ademas se puede usar en el exterior sin problema
israel a castillo b
Comentado en México el 19 de octubre de 2016
La señal de mi compañía de cable era muy débil (vídeo/Internet) debido a la extensión del cable (50 mts) desde el poste hasta el recibidor y el módem dsl y con este amplificador mi señal es excelente y continua.
FAlonsosV
Comentado en México el 30 de noviembre de 2015
Muy buen Producto, recibe varios canales hd con buena calidad, llego en perfectas condiciones, un poco despues de la fecha pero llego muy bien.
Mad Doggerel
Comentado en los Estados Unidos el 25 de febrero de 2013
This device is nice and heavy, with screw holes that let you bolt it to something. The screw holes are too small to accommodate standard drywall screws, which is kind of dumb. I have it screwed to a 2x4 in my attic, which is where the HDTV antenna is.The power cord is only 6 ft. long, so look at your setup before you decide. The power cord APPEARS to be just a length of coax, but I sure couldn't swear to it -- I dunno whether one could substitute a longer cable. So I ended up wiring an AC outlet in my attic right near the antenna. But if the cable you want to amplify comes in the house right near an existing AC outlet (hardly a rare setup), this thing will install really, really fast.When I was shopping, it took me a long time to figure out what kind of amplification I was looking for. This device seems to be designed to solve the problems of people who get good reception, but have to overcome splitters or long cable runs; it does NOT appear to be for those trying to compensate for poor reception.I had great HDTV reception, pulling in over 100 DTV channels locally. But there wasn't enough signal to make it to both of my TVs, each of which was at the end of at least 100 ft. of coax cable. Either TV connected directly to the antenna by itself was fine. Both TVs at once was pure death.There appears to be a lot of variation in people's situations with DTV, so it's hard for a reviewer to generalize. But if you have a well-situated AC outlet, and are trying to solve the problem of multiple TVs on long runs of cable, this appears to be a very good option at an easily affordable price.
Productos recomendados

Mex $2,338.59

Mex $ 1,075 .00 Mex $1,075.00

4.3
Elegir

Mex $7,309.34

Mex $ 1,881 .00 Mex $1,881.00

4.5
Elegir

Mex $720.30

Mex $ 345 .00 Mex $345.00

4.9
Elegir