No hay artículos en el carro
No hay artículos en el carroTaladro piloto agujero y avellanador cónico para tornillos de madera. El diseño integrado de 2 flautas garantiza resultados concentrados uniformes cada vez que se producen. Punta de carburo para resultados de larga duración en madera dura, contrachapada, plásticos, etc. Ángulo #55626 (A°): 49°, diámetro (D): 3/8, (D) vástago: 1/4, longitud total (L): 2-1/8, tamaño de tornillo de madera: 10, D1: 1/8, taladro de repuesto: 630 – 266, 55626 punta de carburo 82 grados cónico rosca #10 3/8 de diámetro x 1/8 taladro Dex
Carpenter's Wife
Comentado en los Estados Unidos el 18 de marzo de 2024
I have been using this in melamine and plywood for a few weeks and it cuts great! will buy again when I inevitably loose this 1
Moises Olivas
Comentado en los Estados Unidos el 5 de enero de 2022
Simple to use, one set screw and cut deeper or less deep. Simple...
holzarbeiter
Comentado en los Estados Unidos el 6 de junio de 2021
Holds up well to daily use even in hardwood. Cuts clean and will outlive an HSS bit 10 to 1 or better in IPE and equivalent hardwood
Chrillo
Comentado en Alemania el 1 de enero de 2021
Sehr gut und. Scharf aber sehr teuer
jaime
Comentado en México el 30 de abril de 2021
lo he usado poco pero la calidad es buena y funciona como uno espera que funcione.me parece elevado el precio
SkyBird
Comentado en los Estados Unidos el 20 de noviembre de 2019
These countersinks from Amana are available in lots of different sizes and the carbide cutters last a long time. After drilling thousands of holes I broke the drill tip on my #10 screw size countersink. Looking for a replacement I found the part number (630-266) on the Amana site but no way to buy it. Searching around I found the same part number at routerbitworld.com for around $2.50 each with $1.00 shipping so I ordered a few. Occasionally, you will break a drill bit so makes sense to have replacements on hand. I broke mine by trying to move to the next hole before fully removing the bit from the last hole and the bits don't like lateral force. In summary, these countersinks are pretty expensive but last so long I think they're a good value. BTW, if you haven't discovered rounterbitworld check them out. They're a great company with fast shipping and a huge inventory of router bits.
Productos recomendados
Mex $179.00
Mex $ 93 .00 Mex $93.00
Mex $823.00
Mex $ 411 .00 Mex $411.00
Mex $594.65
Mex $ 327 .00 Mex $327.00